Rontimco - Factory Direct Discount Prices Dun & Bradstreet
#795493758
 
Main Awning Page General Awning Information Awning FAQ's Attached Awnings Freestanding Awnings Door Hoods Installation Colors Testimonials Request Information

Easy Window Awning Installation

If you can install 8 screws and 6 cotter pins, you can put this window awning up!

Click here for step-by-step picture presentation


Your awning kit includes all materials necessary to install your awning:Awnings parts

  1. Awning (flex) pans
  2. Appropriate # of 1" return arms
  3. 2 adjustable brackets & screws for each return arm
  4. 1 unitizing stringer for each return arm
  5. 3 Cotter pins for each return arm
  6. 2 Screws for each adjustable bracket

 

 

  1. With screws provided, install 2 adjustable brackets (#3) on each side of window on top.( approx. 2" on either side of window and 2" from top of window.) (For wider awnings with more than 2 arms, place additional brackets spaced at even intervals between outside brackets)

  2. Using cotter pin, attach each "stringer" (#4) to top bracket as shown in the attached photo. The
  3. mounted bracket must be spread slightly to accomodate the "stringer".

  4. The return arm (#2) should be mounted in a near horizontal position. This will allow for any awning adjustment you may desire by using any of the prepunched holes in the "stringer". Attach the return arm to the stringer by spreading the "fins" on the arm and inserting the cotter pin through one set of the prepunched holes. Hold the return arm in an approximate horizontal position and place it against the wall to determine the mounting location of the lower bracket. Mark this
  5. location and install lower bracket. Insert cotter pin through lower bracket and return arm.
  6. Tapping the pans into straight alignment
  7. Repeat steps 1 through 3 on each awning support assembly.

  8. To install the "flex" pans, start at the very top of the awning. Begin by hooking ONLY the uppermost side of the pan onto the stringer. (Do not snap into place yet as they will all be snapped in place as the last step.) Place second, third, etc. pans on the stringers until all are laying on the stringers with only the top portion hooked into place. (for the closed view awnings, the flex pans will have to be slid into place from the side because there is not enough room in the front)

  9. Center all pans and line up either side of the pans (while they are laying there) by using a straight edge to "tap" each pan into place in a straight line.

  10. Stand back and "eyeball" the alignment of the pans. When you feel comfortable with the alignment we can snap the "flex" pans into position. Starting at the top , place the palm of your hand directly over the pans at the point where they are resting on the stringer. At this point, (using moderate downward pressure) run your hand down the slats until all pans are "snapped" into place.

  11. Repeat step 7 for each stringer.

  12. Enjoy your Rontimco awning!

  13. Finished!

We're here to help!

Toll Free 800-578-8385

Or email us:
Send us your comments or questions
Rontimco
P.O. Box 1696
Chico, California 95927
Int'l phone  530-589-9000
fax  530-5267-7729
email:  info@rontimco.com



© Copyright Rontimco 1996-2006